| Anti-electronic Short circuit Overload |
| Turn off the UPS power supply |
| Turn off the AC mains power of UPS
Turn off the UPS input circuit breaker |
220/230/240V
200/208V |
|
| Turn off the system enable switch. |
system enable
switch |
| Electrical connection |
| Danger |
|
| Electric shock danger
·Comply with all national and local electrical specifications.
·Wiring work must be completed by qualified electricians.
·Read and follow all safety and installation instructions in this manual
·Read and follow all safety and installation instructions in the manual cited in this manual
Failure to comply with these instructions may lead to equipment damage,personal injury or death. |
| Symmetra LX |
| Please refer to the “Symmetra LX Electrical Installation Guide”for input and output power connections. |
| System installation checklist |
| Please refer to the “Symmetra LX Hardware Installation Guide”and “Symmetra LX Electrical Installation Guide”for detailed instructions |
| Disconnect all devices connected to the UPS. |
|
| Make sure that all rack mounting components are correctly fixed in the rack |
| Verify that the power supply module,battery module,and intelligent module are properly installed. |
| Verify that the Power View is connected to the smart module (IM). |
| Turn on UP SAC mains power supply. |
|
| Turn on input circuit breaker and system enable switch |
system enable
switch |
 |
|
0 |
82001 |
| Ticking may be heard during initial startup.
During initial startup,Power View may display diagnostic messages.These messages can be ignored
Press Esc on the Power View until the monitoring screen is displayed.
Confirm that the input voltage (Vin)matches the voltage of the branch circuit (main circuit) |
| System installation checklist (continued) |
|
|
Turn on the maintenance bypass switch. |
208V
220/230/240V |
|
| lgnore any LED lights or diagnostic messages on the Power View
Press Esc on the Power View until the monitoring screen is displayed.
Confirm input voltage (Vin)matches the voltage of the branch circuit (main circuit). |
| Test the REPO switch.
The system enable switch should be moved to the standby position and the system should be turned off. |
| Turn off input circuit breaker,system enable switch and maintenance bypass switch. |
| Open UPS (continued) |
| Turn on the UPS system enable switch |
system enable
Switch
0 |
|
| To start UPS without AC mains power supply,please press
Hold any cold start button for four seconds. |
 |
| Company Profile |
| MAIN PRODICTS |
